Nano Power Fuel Saver Device- gasoline

The Nano King Fuel Saver has been created through the use of patented nanotechnology.  It consists of a proprietary combination of composite materials.  When properly bonded together and subjected to specific levels of optical and heat energy from various sources this composite material creates a passive energy field.

This energy field produces a low frequency resonance which energizes and miniaturizes hydrocarbon fuel molecules as they pass through the field.  The end result is complete combustion which results in fuel savings and increased engine performance.  In achieving complete combustion emissions are reduced.  The Nano King Fuel Saver works on both gasoline and diesel fuels.  The lifespan of the Fuel Saver is three (3) to five (5) years.

When properly installed the Nano King Fuel Saver can provide users with the following:

 1)     Increased combustion rate and lower emissions.

 2)     Improved engine efficiency and better gas mileage.

 3)     Fuel savings on average:  10~15%, City & 15~25%, Highway.

 4)     Non-utilized gas waste is decreased by an average of more than 15%.

 5)     Non-methane hydrocarbon (NMHC) emissions are decreased by more than 20%.

 6)     Extended engine life.        

 The results for each vehicle will vary based on existing engine conditions when the fuel saver was installed and driving habits of the vehicle operator.  A brand new vehicle will obviously not have the carbon build-up that an older model will have and thus break-in times will vary.    

 Installation Considerations

Professional installation is recommended to ensure that placement is correct.  The Nano King Fuel Saver is not intended for use over metal fuel lines.  If metal fuel lines exist, a rubber or plastic fuel line must replace a portion of the metal line in order to properly install the fuel saver.

 Fuel Saver Taboos

Avoid direct contact with water and direct sunlight as these degrade the composite materials used to create the fuel saver.

Do not install more than two fuel savers on the fuel inlet hose.

Do not inter-mix diesel and gasoline models of fuel savers.

After initial installation do not uninstall and reinstall frequently.

Installation Considerations

 ※  This Nano King Fuel Saver package contains 1 pieces per set.  Do not install more than one set per vehicle.

※  This product is not appropriate for use on vehicles with metal-type or high pressure steel braided fuel line unless a rubber fuel line insert is added using appropriate.

※  The example pictured below is a four-cylinder fuel injection engine.

Installation Procedures
(1) Remove engine dust shield or air filter assembly housing from a cold engine to allow access    to fuel lines as required.

(2) Locate the fuel inlet hose: Please refer to drawings on the back side of the package.

(3) Vehicles with multi-port fuel injection engines will have fuel tracks which will have the rubber fuel inlet hose on one end or the other of the track.  Care must be taken if the fuel saver is not professionally installed to ensure that the device is placed on the inlet and not the return hose. 

  made in taiwan